Ericsson T39 - Network Settings; Searching for Networks

AT Commands Phone Terminal Terminated 96
AT+CSCB Cell Broadcast Message Type
AT+CSAS Save Settings
<tosca>: Integer; GSM 04.11 RP SC type-of-address octet in integer format.
<tosca> Description
129 ISDN / telephony numbering plan, national/international
unknown
Default setting if ‘+’ is not in <sca>
145 ISDN / telephony numbering plan, international number
Default setting if ‘+’ is in <sca>
161 ISDN / telephony numbering plan, national number
128-255 Valid values, see GSM 04.08 section 10.5.4.7
Description: Selects which types of CBMs are to be received by the ME.
Set command: AT+CSCB=<mode>[,<mids>]
Read command: AT+CSCB? Displays the current <mode> and <mids> setting.
Test command: AT+CSCB=? Shows if the command is supported.
Test command
response:
+CSCB: (list of supported <mode>s),(list of supported <mid>s)
Parameters:
<mode>:
<mode> Description
0 Message types in <mids> are accepted
Default setting
1 Message types in <mids> are not accepted
<mids>: String; all possible combinations of CBM message identifiers.
Description: Saves the active message service settings to a non-volatile memory. A TA can contain
several profiles of settings. The settings specified in AT+CSCA and AT+CSCB are
saved. Certain settings, for example SIM SMS parameters, may not be supported by the
storage and can therefore not be saved.
Execution command: AT+CSAS[=<profile>]
Test command: AT+CSAS=? Shows if the command is supported.
Test command
response:
+CSAS: (list of supported <profile>s)
Parameter:
<profile>:
<profile> Description
0 Profile number where settings are to be stored
Default setting