Ericsson T39 - Ensemble C4: Interface Commands

AT Commands Modem Terminated 152
5.3.1 Commands
ATS0 Automatic Answer Control
ATS2 Escape Sequence Character
2 “Drop DTR” behaviour according to &D setting
ATH disconnects the call
5.3 Ensemble C4: Interface Commands
Description: Defines the automatic answering feature of the infrared modem. A non-zero value
specifies the number of rings before the call is answered.
Note: The call always answers in the current fax class, regardless of whether the
incoming call is voice, data, or fax.
Set command: ATS0=[<rcnt>]
Read command: ATS0? Displays the current <rcnt> setting.
Test command: ATS0=? Shows if the command is supported.
Test command
response:
S0: (list of supported <rcnt>s)
Parameter:
<rcnt>:
<rcnt> Description
0 Disable automatic answer
Default setting
1-7 Answer after the specified number of rings
Description: Defines the character to be used as the escape sequence character when switching from
on-line data mode to on-line command mode.
Set command: ATS2=[<esc>]
Parameter:
<esc>:
<esc> Description
43 Escape sequence character
Default setting
0-255 Escape sequence character
Note: If the <esc> parameter is set to a value in the range 128-255, the escape
sequence detection is disabled.
<mode> Description