Ericsson T39 - Ensemble S2: GSM Call Control

AT Commands Modem Terminated 189
5.9.1 Commands
AT+CRC Cellular Result Codes
AT+CR Service Reporting Control
Example: AT*EINA
*EINA: 1
OK
AT*EINA=?
EINA: (1-3)
OK
5.9 Ensemble S2: GSM Call Control
Description: Decides if the extended format of an incoming call indication is used or not. When
enabled, an incoming call is indicated by the unsolicited result code +CRING instead
of the normal unsolicited result code RING.
Set command: AT+CRC=[<mode>]
Read command: AT+CRC? Displays the current <mode> setting.
Test command: AT+CRC=? Shows if the command is supported.
Test command
response:
+CMOD: (list of supported <mode>s)
Parameter:
<mode>:
<mode> Description
0 Disables extended format
Default setting
1 Enables extended format
Description: Enables or disables display of intermediate bearer capability reports during the
handshake phase. This command enables the +CR result code.
Set command: AT+CR=<mode>
Read command: AT+CR? Displays the current <mode> setting.
Test command: AT+CR=? Shows if the command is supported.
Test command
response:
+CR: (list of supported <mode>s)
Parameter:
<mode>:
<mode> Description
0 Disable reporting
Default setting
1 Enable reporting