Ericsson T39 - Display Personalization

AT Commands Phone Terminal Terminated 25
ATS5 Command-Line Editing Character
ATE Command Echo
ATQ Result Code Suppression
Description: Defines the character to be used as the command-line editing character.
Set command: ATS5=<value>
Read command: ATS5? Displays the current <value> setting.
Test command: ATS5=? Shows if the command is supported.
Test command
response:
S5: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0-127 Command line termination character
8 Default setting
Description: Determines if the DCE echoes characters received from the DTE during command
state and on-line command state.
Set command: ATE[<value>]
Read command: ATE? Displays the current <value> setting.
Test command: ATE=? Shows if the command is supported.
Test command
response:
E: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 DCE does not echo characters during command state and
on-line command state
1 DCE echoes characters during command state and on-line
command state
Default setting
Description: Determines if the DCE transmits result codes to the DTE.
Set command: ATQ[=]<value>
Read command: ATQ? Displays the current <value> setting.
Read command
response:
Q: <value>
Test command: ATQ=? Shows if the command is supported.
Test command
response:
Q: (list of supported <value>s)