Ericsson T39 - Ensemble C26: Accessory Identification; AT*EACS Accessory Status

AT Commands Phone Terminal Terminated 34
4.8.1 Commands
AT*EACS Accessory Status
4.8 Ensemble C26: Accessory Identification
Description: Identifies an accessory, reports accessory status, and requests a unique identifier.
Set command: AT*EACS=<accessory_id>,<status_value>[,<unique_id>]
Set command response:*EACS: <unique_id>
Read command: AT*EACS? Displays the current device settings.
Read command
response:
*EACS: <accessory_id1>,<status_value1>,<unique_id1>
[*EACS: <accessory_id2>,<status_value2>,<unique_id2>
...]]
Test command: AT*EACS=? Shows if the command is supported.
Test command
response:
*EACS: (list of supported <accessory_id>s),(list of corresponding status_value>s)
Parameters:
<accessory_id>:
<accessory_id> Description
1 Portable handsfree; presented in ME as
PORTABLE_HF_TXT
2 Vehicle handsfree; presented in the ME as
VEHICLE_HF_TXT
3 RS232 cord; presented in ME as DATA_CABLE_TXT
4 IR device; presented in ME as
INFRARED_MODEM_TXT
6 Charger (intelligent); presented in ME as
DESKTOP_CHARGER_TXT+<nr>
7 Charger (simple); presented in ME as
TRAVEL_CHARGER_TXT
8 Reserved for MC-link
12 External handset; presented in ME as
EXTERNAL_HANDSET_TXT
13 Internal IR device
15 Audio player
50 Chatboard
16-255 Reserved for future accessories; presented in ME as
ACCESSORY_TYPE_TXT+<accessory_id>
<status_value>: Integer type; Status values specific for each accessory.
<status_value> Description
<connected_status> Portable HF status
<connected_status> Vehicle HF status
<connected_status> RS232 cord status