Ericsson T39 - Ensemble C4: Interface Commands; ATS3 Command Line Termination Character; ATS4 Response Formatting Character

AT Commands Phone Terminal Terminated 24
4.3.1 Commands
ATS3 Command Line Termination Character
ATS4 Response Formatting Character
4.3 Ensemble C4: Interface Commands
Description: Defines the character to be used as the line termination character. This is used both for
detection of an end-of-command and in formatting of responses.
Set command: ATS3=<value>
Read command: ATS3? Displays the current <value> setting.
Test command: ATS3=? Shows if the command is supported.
Test command
response:
S3: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0-127 Command line termination character
13 Command line termination character = <CR>
Default setting.
Description: Defines the character to be used as the response formatting character.
Set command: ATS4=<value>
Read command: ATS4? Displays the current <value> setting.
Test command: ATS4=? Shows if the command is supported.
Test command
response:
S4: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0-127 Command line termination character
10 Formatting character = <LF>
Default setting