AT Commands Modem Terminated 153
ATS3 Command Line Termination Character
ATS4 Response Formatting Character
ATS5 Command Line Editing Character
Description: Defines the character to be used as the line termination character. This is used both for
the detection of an end-of-command and in formatting of responses.
Set command: ATS3=<value>
Read command: ATS3? Displays the current <value> setting.
Test command: ATS3=? Shows if the command is supported.
Test command
response:
S3: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0-127 Supported values
13 Command line termination character = <CR>
Default setting
Description: Defines the character to be used as the response formatting character.
Set command: ATS4=<value>
Read command: ATS4? Displays the current <value> setting.
Test command: ATS4=? Shows if the command is supported.
Test command
response:
S4: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0-127 Supported values
10 Formatting character = <LF>
Default setting
Description: Defines the character to be used as the command line editing character.
Set command: ATS5=<value>
Read command: ATS5? Displays the current <value> setting.
Test command: ATS5=? Shows if the command is supported.
Test command
response:
S5: (list of supported <value>s)
To Next Page
Loading...
