Ericsson T39 - Page 205

AT Commands Modem Terminated 203
5.13.3 Unconditional result codes
+CGEV GPRS Event Reporting
+CGREG Network Registration Reporting
Description: This result code is enabled by using the AT+CGEREP command.
Possible unsolicited
result codes:
+CGEV: X, where X is shown below.
<X> Description
REJECT
<pdp_type>,<pdp_addr>
A network request for PDP context activation occurred
when the MT was unable to report it to the TE with a
+CRING unsolicited result code and was automatically
rejected
NW REACT
<pdp_type>,<pdp_addr>
[,<cid>]
The network has forced a network reactivation. The
<cid> that was used to reactivate the context is provided,
if known to the MT
NW DEACT
<pdp_type>,<pdp_addr>
[,<cid>]
The network has forced a network deactivation
The <cid> that was used to deactivate the context is
provided, if known to the MT
ME DEACT
<pdp_type>,<pdp_addr>
[,<cid>]
The mobile equipment has forced a network deactivation
The <cid> that was used to deactivate the context is
provided, if known to the MT
NW DETACH The network has forced a GPRS detach
This implies that all active have been deactivated
These are not reported separately.
ME DETACH The mobile equipment has forced a GPRS detach
This implies that all active have been deactivated
These are not reported separately.
NW CLASS <class> The network has forced a change of phone class
The highest available class is reported
ME CLASS <class> The mobile equipment has forced a change of phone
class
The highest available class is reported
Parameters: See AT+CGDCONT.
Description: This result code is enabled by using the AT+CGREG command.
Possible unsolicited
result codes:
+CGREG: <stat> If AT+CGREG <n>=’1’
+CGREG: <stat>[,<lac>,<ci>] If AT+CGREG <n>=’2’
Parameters:
<stat>:
<stat> Description
0 Not registered
ME is currently searching for an operator to register to
1 Registered, home network