Ericsson T39 - Page 204

AT Commands Modem Terminated 202
AT+CGPADDR Show PDP Address
Extension of ATD - Request GPRS Service
Extension of ATD - Request GPRS IP Service
Description: Returns a list of PDP addresses for the specified context identifiers.
Execution command: AT+CGPADDR=[<cid>[,<cid>[,...]]]
Response: +CGPADDR: <cid>,<pdp_addr><CR><LF>
[+CGPADDR: <cid>,<pdp_addr><CR><LF>
[...]]
Test command: AT+CGPADDR=? Shows if the command is supported.
Test command
response:
+CGPADDR: (list of supported <cid>s)
Parameters:
<cid>: Integer; specifies a particular PDP context definition (see AT+CGDCONT). If no
<cid> is specified, the addresses for all defined contexts are returned.
<pdp_address>: String; identifies the MT in the address space applicable to the PDP. <pdp_addr> is
omitted if none is available.
Description: Makes a GPRS call.
Execution command: ATD*<GPRS_SC>[*[<called_address>][*[<L2p>][*[<cid>]]]]#
Parameters:
<GPRS_SC>: Digit string; a digit string (value=’99’) which identifies a request to use the GPRS.
<called_address>: String; identifies the called party in the address space applicable to the PDP.
<L2p>:
<L2p> Description
0 NULL
1 PPP
2 PAD
3 X25
9yyyy M-xxxx
<cid>: Digit string; specifies a particular PDP context definition.
Description: Makes a GPRS call.
Execution command: ATD*<GPRS_SC_IP>[*<cid>]#
Parameters:
<GPRS_SC>: Digit string; a digit string (value=’98’) which identifies a request to use the GPRS
with IP (PDP types IP and PPP).
<cid>: Digit string; specifies a particular PDP context definition.