Ericsson T39 - Page 132

AT Commands Phone Terminal Terminated 130
AT*ENAD Internet Account Define
<iphone>: Integer; phone current consumption. Number of mA. Range: 0-65500.
<acapacity>: Integer; added capacity during charge. Number of mAh, multiplied by 20.
Range: 0-65500.
<ccapacity>: Integer; consumed capacity during charge. Number of mAh, multiplied by 20.
Range: 0-65500.
<ncapacity>: Integer; nominal capacity during charge. Number of mAh, multiplied by 20.
Range: 0-65500.
<tempbatt>: Integer; battery temperature in degrees Celsius, -20 deg C - +70 deg C.
<tempphone>: Integer; phone temperature in degrees Celsius, -20 deg C - +70 deg C.
<bcapacity>:
<bcapacity> Description
0 Slim battery
1 Standard battery
2 High-capacity battery
<chargestate>:
<chargestate> Description
0 Start
1 Charge
2 Await
3 Handheld
4 Charge completed; safety timer
5 Charge completed; dT/dt
6 Charge completed; dv2/dt2
7 Charge completed; flat V
Description: This command is used for defining an Internet Account. An IA is called a “Data
Account” in the phone MMI.
Set command: AT*ENAD=[<index>][,<name>,<userid><password>,<bearer>,(bearer settings_1)]
<bearer> (bearer_settings_1)
0 <dialup_nr>,<dial_type>,<data_rate>
1 <pref_serv>,<pap_chap>
Set command response:*ENAD: <index>[,<cid>]
Note: If the AT*ENAD command is issued with only the <index> parameter, this is
interpreted as a request for the corresponding account to be deleted.
Read command: AT*ENAD? Displays the current <index>s
<name>s,<userid>,,<bearer>,(bearer_settings_2).
Note: Extra comma between <userid> and <bearer>.
<bearer> (bearer_settings_2)
0 <dialup_nr>,<dial_type>,<data_rate>,<lock_state>
1 <pref_serv>,<pap_chap>,<cid>,<lock_state>