Ericsson T39 - Page 163

AT Commands Modem Terminated 161
AT+ILRR Cable Interface Local Rate Reporting
Parameter:
<rate>:
<rate> Description
Discrete integer value The rate, in bits per second, at which the DTE-DCE
interface should operate. Currently, the following rates are
supported:
0, 300, 1200, 2400, 4800, 9600, 14400, 19200, 28800,
38400, 57600, 115200, 230400, and 460800
If unspecified, or set to zero, automatic detection is selected,
and the character format is forced to auto-detect
(AT+ICF=0)
Description: Specifies whether or not the +ILRR intermediate result code is transmitted from the
DCE to the DTE. The <rate> reported shall represent the current DTE-DCE rate. If
enabled, the intermediate result code is transmitted after any modulation, error control
or data-compression reports are transmitted, and before any final result code (for
example CONNECT) is transmitted. The <rate> is applied after the final result code is
transmitted.
Set command: AT+ILRR=<value>
Read command: AT+ILRR? Displays the current <value> setting.
Test command: AT+ILRR=? Shows if the command is supported.
Test command
response:
+ILRR: (list of supported auto detectable <value>s)
Parameter:
<value>:
<value> Description
0 Disables reporting of local port-rate (+ILRR: is not
transmitted)
Default setting
1 Enables reporting of local port-rate (+ILRR: is transmitted)