Ericsson T39 - Page 172

AT Commands Modem Terminated 170
AT+FBADLIN Bad Line Threshold
AT+FBADMUL Error Threshold Multiplier
91 Missing EOL after 5 seconds
93 TAE to TE buffer overflow
94 Bad CRC or frame (ECM or BFT modes)
100 Unspecified Receive Phase D errors
101 RSPREC invalid response received
102 COMREC invalid response received
103 Unable to continue after PIN or PIP
120-255 -reserved codes-
Description: Sets the maximum acceptable consecutive number of bad lines.
Set command: AT+FBADLIN=<value>
Possible set command
responses:
Copy Quality OK.
Copy Quality Not OK.
Read command: AT+FBADLIN? Displays the current <value> setting.
Test command: AT+FBADLIN=? Shows if the command is supported.
Test command
response:
+FBADLIN: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Error checking not present, or disabled
Default setting
Description: Sets the maximum acceptable percentage of bad lines per page multiplication value.
Set command: AT+FBADMUL=[<value>]
Read command: AT+FBADMUL? Displays the current <value> setting.
Test command: AT+FBADMUL=? Shows if the command is supported.
Test command
response:
+FBADMUL: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Error checking not present, or disabled
Default setting
20 Corresponds to a 5% error rate
0-255 Valid values