evertz 5601MSC - Configuring the Outputs; Table 4-6: Top Level of the Output Setup Menu

Model 5601MSC
Model 5601MSC Master SPG/Master Clock System
MASTER CLOCK Revision 2.2 Page - 97
4.4. CONFIGURING THE OUTPUTS
The OUTPUT menu is used to configure the various outputs of the 5601MSC. The chart below shows
the items available in the OUTPUT menu. Sections 4.4.1 and 4.4.2 give detailed information about each
of the sub-menus.
LTC 1
Configures LTC/IRIG output 1
LTC 2
Configures LTC/IRIG output 2
SYNC 1
Configures the Sync 1 output
SYNC 2
Configures the Sync 2 output
SYNC 3
Configures the Sync 3 output
SYNC 4
Configures the Sync 4 output
SYNC 5
Configures the Sync 5 output
SYNC 6
Configures the Sync 6 output
10 MHz
Configures the 10MHz output
Wordclock
Configures the Wordclock output
SDI TG 1
Configures the SDI Test Generator 1 output
SDI TG 2
Configures the SDI Test Generator 2 output
SDI TG 3
Configures the SDI Test Generator 3 output
SDI TG 4
Configures the SDI Test Generator 4 output
ATG 1
Configures the Analog Video Test Generator 1 output
ATG 2
Configures the Analog Video Test Generator 2 output
Analog Audio
Configures the Analog Audio outputs
AES Audio
Configures the AES1, AES2, and DARS outputs
Global pedestal
Global control of NTSC setup pedestal on Sync and ATG outputs
Global Phasing
Global phase controls for GPS, Video, 10MHz, and Internal lock modes
Table 4-6: Top Level of the Output Setup Menu