Model 5601MSC
Model 5601MSC Master SPG/Master Clock System
Page - 168 Revision 2.2 TECHNICAL DESCRIPTION
5.1.7. Analog Composite Video Test Signal Generators (SDTG, HDTG, or 3GTG options)
Standard: SMPTE ST 170 (NTSC-M), ITU-R BT.1700-1 (PAL-B)
Number of Outputs: 2 individual test generators with 1 output each
Connector: BNC per IEC 61169-8 Annex A
White Level (PAL-B): 700mV ± 5mV
Sync Level (PAL-B): -300mV ± 5mV
DC Offset: < 50mV
Chroma to Luma Delay: < ± 3ns
Chroma to Luma Gain: 100.0% ± 0.5%
Differential Gain: < 0.50%
Differential Phase: < 0.50º
Frequency Response: ripple < 0.30dB to 5.8MHz
SCH Phase: 0º ± 1.0º
Output Impedance: 75Ω
Return Loss: > 30dB to 10MHz
SNR: > 75dB
(RMS)
5.1.8. Analog Audio Tones Generator (SDTG, HDTG, or 3GTG options)
Number of Outputs: 2
Type: Balanced analog audio
Connector: 6 pins on 16-pin removable terminal strip
Output Impedance: 66Ω balanced
Signal Level: -30dBu to +10dBu
DC Offset: < 50mV
THD+N Ratio: < -100dB (1kHz tone at +10.0dBu)
5.1.9. SDI Test Generator Outputs (SDTG, HDTG, or 3GTG options)
SDI Standard: SMPTE ST 259-C (270 Mb/s) 4:2:2 10 Bit YCbCr
Image Standards: SMPTE ST 125 (525 line and 625 line 13.5 MHz sampling)
Number of Outputs: 4 individual test generators with 2 outputs each (8 total)
Embedded Audio: Up to 4 groups as specified in SMPTE ST 272
Selectable tone frequencies (from 20Hz to 20kHz) and audio level control
Connectors: BNC per IEC 61169-8 Annex A
Signal Level: 800mV ± 10% nominal, 1600mV high drive enabled
Rise and Fall Time: 400ps to 800ps (20% to 80%)
Rise and Fall Overshoot: < 10% of amplitude
Return Loss: > 20 dB 100kHz to 270MHz
Wide Band Jitter: < 0.2 UI (10Hz high-pass filter)
To Next Page
Loading...
