evertz X1201S - Chapter 2: Installation

X1200 Series Router Manual
INSTALLATION
Revision 1.3.2
CHAPTER 2: INSTALLATION
TABLE OF CONTENTS
2. INSTALLATION................................................................................................................................ 2-1
2.1. REAR PANEL.......................................................................................................................... 2-1
2.1.1. Standard Definition Digital Video Connections (X1200S) ............................................ 2-1
2.1.2. High Definition Digital Video Connections (X1202H) ................................................... 2-1
2.1.3. AES Audio Connections ............................................................................................... 2-2
2.1.3.1. Audio Connections on Router Models with the AES Option Fitted. ............. 2-2
2.1.3.2. Audio Connections On Early Router Models With The AES Option Fitted.
(two breakout panels shipped)..................................................................... 2-2
2.1.3.3. Audio Connections on Router Models with the AES4 Option Fitted. ........... 2-3
2.1.4. Reference Connections................................................................................................ 2-3
2.1.5. Remote Control Connections ....................................................................................... 2-3
2.1.6. Power Connections ...................................................................................................... 2-5
2.2. MOUNTING ............................................................................................................................. 2-5
2.3. POWER REQUIREMENTS...................................................................................................... 2-5
2.3.1. Selecting the Correct Mains Voltage ............................................................................ 2-5
2.3.2. Changing the Fuses ..................................................................................................... 2-6
2.4. CONNECTING THE REMOTE CONTROL PANEL ................................................................ 2-6
2.4.1. Connecting The Primary Remote Control Panel (RCP Version) .................................. 2-6
2.4.2. Connecting A Second Remote Control Panel .............................................................. 2-7
2.5. CONNECTING THE GENERAL PURPOSE INPUTS AND OUTPUTS .................................. 2-7
2.5.1. Connecting the General Purpose Inputs ...................................................................... 2-8
2.5.2. Connecting the General Purpose Outputs ................................................................... 2-9
2.5.3. GPI/O Examples........................................................................................................... 2-9
2.6. CONTROLLING THE ROUTER USING THE EXTERNAL SERIAL PROTOCOL................ 2-10
2.6.1. Connecting the Router to a Grass Valley Ten XL ASCII Control Device ................... 2-10
Figures
Figure 2-1: X1202H-AES4 Rear Panel Layout...................................................................................... 2-1
Figure 2-2: X1202S-AES4 Rear Panel Layout ...................................................................................... 2-1
Figure 2-3: X1202ABO Audio Breakout Panel Layout .......................................................................... 2-2
Figure 2-4: General Purpose I/O Schematic ......................................................................................... 2-7
Figure 2-5: Powering the General Purpose Input Opto-Isolators from the Router ................................ 2-8
Figure 2-6: Powering the General Purpose Input Opto-Isolators from an External Power Supply........ 2-9
Figure 2-7: GPIO Example – Auto Changeover to Input 2 on Loss of Input 1 .................................... 2-10