X1200 Series Router Manual
OPERATION
Revision 1.3.2
Page 3-5
The SETUP menu system uses the 16 digit alphanumeric display and provides a quick, intuitive method of
configuring the Router. The SETUP Menu contains items that pertain to the overall operation of the
router. These items are normally only required to be set up at installation time, and do not pertain to the
day to day operation of the unit.
3.4. NAGIVATING THE SETUP MENU
To enter the on-screen menu system, press the SETUP key. This will bring you to the main Setup menu
where you can use the ↑ & ↓ keys to move up and down the list of available sub menus. Top level menu
items are shown in UPPERCASE. Once you have chosen the desired sub menu, press the SELECT key
to select the next menu level.
Once in a sub menu, there may be another menu layer (shown in Title Case), or there may be a list of
parameters to adjust (shown in lower case). If there is another set of menu choices, use the ↑ & ↓ keys to
select the desired menu item and press the SELECT key. Continue this process until you get to the
bottom of the menu tree where the list of parameters to be adjusted is shown.
To adjust any parameter, use the ↑ & ↓ keys to move up or down to the desired parameter. To view the
possible values for that item, press the SELECT key. The current value for that parameter will be shown
blinking. Pressing the ↑
&
↓
keys allows you to show the possible values for the selected menu item. The
various menu values that are not currently selected will NOT be blinking. When you have stopped at the
desired value, press the SELECT key to save your selection. The value shown will begin blinking;
indicating that it is the current value. To move up one level in the menu press the SETUP key. The
parameter value that is blinking will become the current value when you exit the menu system by selecting
the Exit and Save menu choice.
You can select other parameters from that sub menu by using the ↑ & ↓ keys, followed by the SELECT
key. Alternately you can move up one menu item by pressing the SETUP key.
When you have made all the desired changes, press the SETUP key one or more times until you return to
the top of the Menu tree where you will be presented with an Exit menu. Using the ↑ & ↓ keys, choose one
of the three choices and then press the SELECT key. A description of the actions taken for each Exit
menu choice is shown below. You will be prompted to press the SELECT key one more time to confirm
your decision. Pressing the SETUP key at this time will return you to the Exit menu level.
SAVE AND EXIT
Selecting this choice will make all the changes you made while in the Setup
menu permanent. You will exit the Setup menu and return to normal front
panel operation.
EXIT NO SAVE
Selecting this choice will discard all the changes you made in the Setup menu
and restore the settings that were in use when you entered the Setup menu.
You will exit the Setup menu and return to normal front panel operation.
RETURN TO MENU
You will return to the top level of the Setup menu at the menu item you last
selected.
Each of the menu items is described in the following sections, with an explanation of what each choice
does.
To Next Page
Loading...
