X1200 Series Router Manual
TECHNICAL DESCRIPTION
Revision 1.3.2
Page 4-1
4. TECHNICAL DESCRIPTION
4.1. SPECIFICATIONS
4.1.1. Video Specifications (X1200S Series)
4.1.1.1. SDI Video Inputs
Standards: SMPTE 259M (270Mb/s, 360Mb/s, 540Mb/s)
Number of Inputs: 12
Connector: BNC per IEC 169-8
Equalisation: Automatic up to 250m @ 270 Mb/s
with Belden 8281 or equivalent cable
Return Loss: > 15 dB up to 540 Mb/s
Input Timing (V1 buss on SoftSwitch and Embedded SoftSwitch equipped models only)
Input Range: measured with respect to the Genlock reference
± one half line when Course phase = 1, Fine phase = 0
4.1.1.2. SDI Video Outputs
Standard: Same as Input
Number of Outputs:
X1201S 1 buss ,2 outputs, input 1 bypass protected when bypass relay option is installed
X1202S 2 busses, 2 outputs per buss, input 1 and 12 bypass protected when bypass relay
option is installed
Connector: BNC per IEC 169-8
Signal Level: 800mV nominal
DC Offset: 0V ±0.5V
Rise and Fall Time: 200ps nominal
Overshoot: <10% of amplitude
Return Loss: > 15 dB up to 540 Mb/s
Wide Band Jitter: < 0.2 UI
Output Timing (V1 buss on SoftSwitch and Embedded SoftSwitch equipped Models only)
Output phase: measured with respect to the Genlock reference
Adjustable 1 line to a full frame of delay - set by Coarse phase parameter
Note: While the output timing is adjustable, the active video content will align to the
nearest line. Output timing is measured with respect to the Genlock reference and
is associated to the V1 Buss Only
To Next Page
Loading...