X1200 Series Router Manual
OPERATION
Revision 1.3.2
Page 3-25
3.15. SAVING AND RECALLING CONFIGURATION PRESETS
The PRESETS menu allows the user to save specific configurations to one of two non-volatile presets.
Using this menu, these presets can be restored, or the user can restore the router to its factory preset
configuration. The chart below shows the items available in the PRESETS menu. Sections 3.13.1 to
3.13.5 give detailed information about each of the sub menus.
Load Factory
This allows the user to restore the router to the factory default configuration.
Load Preset 1
This allows the user to recall the router configuration in user preset 1.
Load Preset 2
This allows the user to recall the router configuration in user preset 2.
Save Preset 1
This allows the user to save the current router configuration to user preset 1.
Save Preset 2
This allows the user to save the current router configuration to user preset 2.
3.15.1. How to Restore the Factory Default Settings
PRESETS
Load Factory
This menu item is used to restore the factory default values of all the
programmable features in the router.
Pressing the SELECT key when this menu item is shown will prompt you to
confirm that you want to load the Factory Default configuration. Doing this
will override all of your current configuration items. To proceed press the
SELECT key one more time. The front panel display will briefly show a
message indicating that the Factory default configuration has been loaded.
The configuration will become active until you exit the menu system with the
Exit and Save menu choice.
3.15.2. How to Recall a Saved User Preset Configuration
PRESETS
Load Preset 1
This menu item is used to recall the values of all the programmable features
in the router saved in user preset 1. (A similar menu item allows you to
recall user preset 2).
Pressing the SELECT key when this menu item is shown will prompt you to
confirm that you want to load the user preset configuration. Doing this will
override all of your current configuration items. To proceed press the
SELECT key one more time. The front panel display will briefly show a
message indicating that the user preset configuration has been loaded. The
configuration will become active until you exit the menu system with the Exit
and Save menu choice.
To Next Page
Loading...
