evertz X1201S - Step 4 - Upload the New Label File to the Router

X1200 Series Router Manual
Page 4-8
Revision 1.3.2
TECHNICAL DESCRIPTION
The file structure is as follows:
[category_a]<CR><LF>
labelvar_a1=value 1<CR><LF>
labelvar_a3=value 2<CR><LF>
labelvar_a2=value 3<CR><LF>
[category_b]<CR><LF>
labelvar_b1=value<CR><LF>
labelvar_b2=value<CR><LF>
<CR><LF>
<CR><LF>
<CR><LF>
Note: <CR><LF> = Enter key
Each category is enclosed in square brackets [] and identifies the input category (e.g.[VIDEO],
[AUDIO1A]) for a group of associated label variables. The label variables must follow their associated
category in the file and represent the label names that can be changed in the router. The value that
follows the equals sign is a 16 character maximum length text string that is assigned to the variable.
Alphanumeric characters such as a-z, A-Z, 0-9 and punctuation (ISO Character values 32 to 126) are
valid. Label variables can be in any order as long as they occur in the correct category section of the
file. Physical inputs on the router that do not have an associated label variable will retain their original
value when the label file is uploaded to the router. If a label variable is specified more than once, the
last value in the file will be used.
4.3.4. Step 4 – Upload the New Label file to the Router
9. Invoke the Label Receive File mode using the front panel Setup Menu. (See section 3.2 for information
on how to operate the front panel menus.)
• Press the SETUP button once to enter the front panel menu.
• Press the ↑ & ↓ keys until the front panel display reads INPUT LABEL.
• Press the SELECT button
• Press the ↑ & ↓ keys until the front panel display reads Input Label File.
• Press the SELECT button.
• Press the ↑ & ↓ keys until the front panel display reads Receive file?
• Press the SELECT button. A text prompt Send file to router now will appear on the
terminal program screen.
10. Configure the terminal program to send the label text file. If you are using HyperTerminal this is done
using the Transfer/Send Text File menu item.
11. Exit the menu system by pressing the SETUP key one or more times until you return to the top of the
Menu tree where you will be presented with an Exit menu. Using the ↑ & ↓ keys, choose the SAVE
AND EXIT item and then press the SELECT key. You will be prompted to press the SELECT key one
more time to confirm your decision.