X1200 Series Router Manual
Page 4-2
Revision 1.3.2
TECHNICAL DESCRIPTION
4.1.2. Video Specifications (X1200H Series)
4.1.2.1. HD Video Inputs
Standards: SMPTE 292M (1.5 Gb/s)
Number of Inputs: 12
Connector: BNC per IEC 169-8
Equalisation: Automatic up to 100m
with Belden 1694 or equivalent cable
(50 m on Inputs 1 and 12 when the optional Bypass relays are installed)
Return Loss: > 15 dB up to 1.5 Gb/s
Input Timing (V1 buss on SoftSwitch and Embedded SoftSwitch equipped models only)
Input Range: measured with respect to the Genlock reference
± one half line when Course phase = 1, Fine phase = 0
4.1.2.2. HD Video Outputs
Standard: Same as Input
Number of Outputs:
X1201H 1 buss ,2 outputs, input 1 bypass protected when bypass relay option is installed
X1202H 2 busses, 2 outputs per buss, input 1 and 12 bypass protected when bypass relay
option is installed
Reclocking on outputs may be turned off on each buss independently.
Connector: BNC per IEC 169-8
Signal Level: 800mV nominal
DC Offset: 0V ±0.5V
Rise and Fall Time: 200ps nominal
Overshoot: <10% of amplitude
Wide Band Jitter: < 0.2 UI
Return Loss: > 15 dB up to 1 Gb/s, > 12 dB up to 1.5 Gb/s
Output Timing (V1 buss on SoftSwitch and Embedded SoftSwitch equipped Models only)
Output phase: measured with respect to the Genlock reference
Adjustable 1 line to a full frame of delay - set by Coarse phase parameter
Note: While the output timing is adjustable, the active video content will align to the
nearest line. Output timing is measured with respect to the Genlock reference and
is associated to the V1 Buss Only
4.1.3. Video Reference
Type: Menu selectable - depends on video format (See section 2.1.4)
NTSC or PAL Colour Black 1 V p-p
Composite bi-level sync (525i/59.94 or 625i/50) 300 mV
HD Tri-level Sync (X1202H versions only)
Connectors: BNC per IEC 169-8
Termination: High impedance loop through
To Next Page
Loading...