Evoqua Rivo I - Page 97

System messages
11
Rivo™ I Controller EN
95
Evoqua Water Technologies GmbH | W3T597263 Issue 01-0624
E-RIV-133 Error Input signal outside of measurable range. Check the input signal and wiring.
E-RIV-134 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-135 Error Missing factory calibration in the Indicated
module.
Please contact service.
E-RIV-136 Info Communication error in the indicated
module.
Please contact service.
E-RIV-142
E-RIV-144 Error Load error
The mA output cannot drive its mA output
current through the connected current
loop (max. 500 Ohm at 20 mA).
Check the signal cable for interruption.
If the output is not required, it can be
deactivated.
E-RIV-145 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-146 Error Missing factory calibration in the Indicated
module
Please contact service.
E-RIV-147 Info YES Indicates that a calibration is in progress
E-RIV-149 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-150 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-151 Info YES Note for a successful upgrade. Data was
successfully migrated.
Message can be deleted by ACK.
E-RIV-152 Info YES
E-RIV-158 Info YES Calibration data are outside the valid
range.