Evoqua Rivo I - Page 96

11
System messages
EN Rivo™ I Controller
94
W3T597263 Issue 01-0624 | Evoqua Water Technologies GmbH
E-RIV-120 Error Input signal outside of measurable range. Check input signal and wiring.
E-RIV-121 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-122 Error Missing factory calibration in the Indicated
module.
Please contact service.
E-RIV-123 Info Communication error in the indicated
module.
Please contact service.
E-RIV-124 Error Input signal outside of valid range. Eingangssignal und Verdrahtung über-
prüfen.
Connecting cable is interrupted. Falls der Eingang nicht benötigt wird,
kann er deaktiviert werden.
E-RIV-125 Error Input signal outside of valid range. Eingangssignal und Verdrahtung über-
prüfen.
Incorrect signal source. Check the signal source.
E-RIV-126 Error Input signal outside of measurable range. Check the input signal and wiring.
E-RIV-127 Error Input signal outside of measurable range. Check the input signal and wiring.
E-RIV-128 Error Hardware or electronic error in the Indi-
cated module.
Please contact service.
E-RIV-129 Error Missing factory calibration in the Indicated
module.
Please contact service.
E-RIV-130 Error Actuator was unlocked.
E-RIV-131 Info Communication error in the indicated
module.
Please contact service.
E-RIV-132 Error Input signal outside of measurable range. Check the input signal and wiring.