8.21.13 Xesar tablet error (ARES FX716M)
Tip: If the tablet has been disconnected from the PC and can not be turned on
again, press the reset button on the back of the Xesar tablet and restart the Xesar
tablet.
8.21.14 XVN time delay
The update of the Delta blacklist may take up to 60 seconds.
8.21.15 Tablet error display XTDE17
The XTDE17 error occurs when a component reset has failed.
8.21.16 Installation Manager no longer recognises a coding station
if it is plugged into another USB port.
Workaround: Close and restart the Installation Manager.
8.21.17 No dashboard display in the browser
If the Xesar 3.0 software display no data on the dashboard, this may be due to unusually
high CPU utilisation.
Remedy: Stop and restart the installation in Installation Manager.
8.21.18 Blue screen after removing a medium from the coding station
Windows 7 computers may experience bluescreen errors when using the HID OmniKey
5421 coding station.
8.21.19 Problems detecting media with Windows 10 Pro x64 Version build
1709
If this error occurs than update to Windows 10 Pro x64 build 1803.
8.21.20 Tablet synchronisation
When a configuration maintenance task is re-synchronised to the SW, it takes a few sec-
onds for the synchronisation maintenance task of that installation location to get onto the
tablet.
8.21.21 Tablet synchronisation
It is recommended to synchronise more often. If a lot of logs are stored on the tablet
then the synchronisation time take several minutes.
To Next Page
Loading...