IMPORTANT: Make sure that you perform a manual backup in the Installation
Manager after the AdminCard exchange. Otherwise, a restore will not fit the
new AdminCard.
8.17 Revoking the process of adding a component
If you have added an incorrect component to the installation location, you can once again
remove the component here. For this purpose, click the dedicated button at the end of the
input field.
Figure 240 – Revoking the process of adding a component
You also must not create the installation location from scratch but can just select a new
component.
ATTENTION: This only functions before initializing and, if necessary, only after re-
setting to construction site mode.
To Next Page
Loading...
