746 C - 844 C 43 532150 - Rev.A
Translation of the original instructions
ENGLISH
8.5 INDICATOR LIGHT/COURTESY LIGHT,
TRAFFIC LIGHT CONTROL, ELECTRIC
LOCK
i
Do not exceed the maximum load of the output (24 V
"
,
100 mA). If necessary, use a relay and a power supply
that is external to the board.
1. Connect the device to programmable output OUT1
or OUT2.
2. In advanced programming, program the output:
- function of output:
o1 (OUT1), o2 (OUT2)
- output contact type (NO/NC):
P1 (OUT1), P2
(OUT2)
- activation time (only for timed functions):
t1
(OUT1),
t2 (OUT2)
■ Indicator light
o1/o2 = 02
The indicator light remotely indicates the status of
the automation:
indicator light automation
off closed
on opening/open/paused
flashing closing
■ Courtesy light (timed)
o1/o2 = 03
The courtesy light turns on for the duration of the
movement and remains on for the time set in
t1/t2.
■ Electric lock
o1/o2 = 11
The electric lock is activated just before opening and
closing.
■ Traffic light control
o1/o2 = 13
The traffic light control is on when the automation is
opening and flashes during closing (with pre-flashing
for 3 s before starting to close).
8.6 RADIO SYSTEM
The E781 is fitted with an integrated two-channel
decoding system that requires either a XF FDS or XF
radio module to be installed, to allow various types of
FAAC radio controls to be memorised.
■ Radio module XF FDS
The XF FDS radio module allows you to memorise
FAAC radio controls with FDS coding. A maximum
of 251 codes can be memorised. FDS technology is
characterized by dual frequency transmission (433
and 868 MHz). XF FDS is not compatible with SLH,
SLH LR, LC/RC, DS radio controls.
■ Radio module XF433 or XF868
The XF433 or XF868 radio module allows you to me-
morise FAAC radio controls that use the following
types of radio code: SLH, SLH LR, LC/RC, DS. It is
also possible to use FDS radio controls by following
a specific procedure to convert them into SLH mode
(see instructions). A maximum of 256 codes can
be memorised. The various types of radio codes
can coexist, but the radio module and all the radio
controls must have the same frequency.
The commands available are:
- OPEN A on radio channel 1 (CH1)
- OPEN B/CLOSE on radio channel 2 (CH2)
- Alternatively, the second radio channel can be
enabled to activate a programmable output
(§ Advanced programming)
When it is switched on, the board detects the module
and activates the corresponding radio mode.
If the board detects a radio module that is not compa-
tible with any of the radio controls that have already
been memorised, the 2 RADIO LEDs flash alternately
to indicate the error. It is possible to delete the radio
controls, or install a compatible radio module.
i
To check which radio mode is active on the board, press
the ++ and
--
buttons at the same time.
The display shows the corresponding code (after any
Errors / Alarms that may be present):
SL compatible with SLH, SLH LR, LC/RC, DS radio
controls
Fd compatible with FDS radio controls
■ Memory full warning
If the RADIO LED on the board turns off instead of
flashing for 20 s during the radio control memorisation
procedure, it means that the radio memory is already
full and it is not possible to continue.
To Next Page
Loading...
