746 C - 844 C 5 532150 - Rev.A
Translation of the original instructions
ENGLISH
2.4 LIMITATIONS OF USE
2.5 UNAUTHORISED USE
The maximum force required to move the leaf by
hand over its entire length of travel must be 225 N
for residential areas and 260 N for industrial or com-
mercial areas.
The maximum force required to start the movement
must be less than the maximum torque at initial thrust
of the operator indicated in the technical data.
The leaf must fall within the dimensional and weight
limits indicated in the technical data.
The presence of weather conditions such as snow, ice
and strong wind, even occasional, could affect the
correct operation of the automation, the integrity of
the components and be a potential source of danger
(see § Emergency use).
746 C - 844 C is not designed to be a security (break-in
protection) system.
If there is a pedestrian access gate integrated in the leaf
of the gate, the motorised movement must be disabled
when the pedestrian gate is not in a safe position.
The installation must be visible during the day and
at night. If it is not, appropriate solutions must be
provided to make the fixed and moving parts visible.
Implementing the automation requires the installa-
tion of the necessary safety devices, identified by the
installer through an appropriate risk assessment of
the installation site.
- Uses other than the intended use are prohibited.
- It is prohibited to install the automation system
outside of the limits specified in the Technical Data
and in the Mechanical and Electrical Installation
Requirements.
- It is forbidden to use 746 C - 844 C in a construc-
tional configuration other than the one provided
by the manufacturer.
- No component part of the product may be mo-
dified.
- It is prohibited to install the automation system
on escape routes.
- It is prohibited to install the automation system to
create fire doors.
- It is prohibited to install the automation system in
environments in which there is a risk of explosion
and/or fire: the presence of flammable gases or
fumes is a serious safety hazard (the product is
not ATEX certified).
- It is prohibited to power the system with energy
sources other than those specified.
- It is prohibited to integrate commercial systems
and/or equipment other than those specified, or
use them for purposes not intended and authorised
by their respective manufacturers.
- Do not allow water jets of any type or size to come
into direct contact with the gear motor.
- Do not expose the gear motor to corrosive chemi-
cals or atmospheric agents.
- It is prohibited to use and/or install accessories
which have not been specifically approved by
FAAC S.p.A.
- It is prohibited to use the automation system before
performing commissioning.
- It is prohibited to use the automation system in the
presence of faults which could compromise safety.
- It is prohibited to use the automation system with
the fixed and/or mobile guards removed or altered.
- Do not use the automation system unless the area
of operation is free of persons, animals or objects.
- Do not enter/remain in the area of operation of the
automation system while it is moving.
- Do not try to prevent the movement of the auto-
mation system.
- Do not climb on, hold onto or let yourself be pulled
by the leaf. Do not climb onto the gear motor.
- Do not allow children to approach or play in the
area of operation of the automation system.
- Do not allow the control devices to be used by
anyone who is not specifically authorised and
trained to do so.
- Do not allow the control devices to be used by
children or persons with mental and physical de-
ficiencies unless they are supervised by an adult
who is responsible for their safety.
- During manual operation, gently guide the leaf
the whole way, do not push it and let it slide freely.
To Next Page
Loading...
Need help?
General
