14
746 C - 844 C 20 532150 - Rev.A
6
1
5
4
3
5
5
TE 6.3 x 25 UNI 6950
6.5 x 18 x 2 UNI 6953
2
Translation of the original instructions
ENGLISH
NYLON RACK
i
Rack thickness: 20 mm for leaves weighing up to 400
kg max.
1. Close the leaf manually. Rest an element of the
rack on the pinion. Make sure that it is horizontal
using a spirit level.
2. Drill holes at the centre of the slots.
3. Fasten using suitable screws and washers.
i
Self-tapping screws and washers are available for
aluminium or steel and should be ordered separately.
4. Move the leaf manually. Install the next interlo-
cking section at the end of the previous one and
rest it on the pinion. Make sure that it is horizontal
using a spirit level.
5. Drill holes at the centre of the slots.
6. Fasten using suitable screws and washers.
Repeat the procedure to complete the rack.
i
If an element has to be shortened, cut it with an angle
grinder so that you leave two fastening points.
To Next Page
Loading...
