FAAC 746 C - Memorising DS Radio Controls; Deleting Radio Controls

746 C - 844 C 45 532150 - Rev.A
Translation of the original instructions
ENGLISH
1. Take a radio control that is already in use and move
close to the board.
2. Press buttons P1 and P2 simultaneously on the radio
control that is already in use and release them when
the LED on the radio control starts to flash slowly
for 5 s (time available for the next step).
3. Press and release the button that has already been
memorised (the corresponding RADIO LED on the
board starts to flash for 20 s, the time available for
the next step).
4. Press the button to be memorised on the new
radio control (the corresponding RADIO LED on
the board becomes steady for 2 s to confirm the
memorisation. It then starts to flash again and ano-
ther radio control can be memorised within 20 s).
The procedure ends after 20 s if no further radio
controls are memorised and the RADIO LED switches
off. To add additional radio controls, repeat the
procedure from step 1.
MEMORISING DS RADIO CONTROLS
1. Set the required combination of the DIP switches
on the radio control (avoid setting them to all ON
or all OFF).
2. On the board, press the
++ (memorise OPEN A) or
--
(memorise OPEN B/CLOSE) button and release it
when the corresponding RADIO LED (RADIO1 or
RADIO2) starts to flash for 20 s (time available for
the next step).
i
If the RADIO LED at step 2 turns off instead of flashing
for 20 s, it means that the radio memory is already full
and it is not possible to continue.
3. Press and release the button on the radio control to
be memorised. The corresponding RADIO LED on
the board becomes steady for 1 s and then switches
off (memorisation complete).
4. To memorise other radio controls, it is possible
to set a DIP switch combination that has already
been memorised or repeat the procedure for new
combinations.
8.7 DELETING RADIO CONTROLS
i
This procedure cannot be reversed. It will delete ALL
radio control codes that have been memorised as OPEN
A and OPEN B/CLOSE. The deletion procedure is only
active when the display shows the automation status.
1. Press the
--
or ++ button and do not release it until
the LED sequence has finished:
- after 1 s the RADIO2 LED starts flashing slowly
- after 5 s, the RADIO1 and RADIO2 LEDs both start
to flash quickly (deletion in progress)
- after 7 s both the LEDs come on steadily (deletion
complete)
2. Release the button, both LEDs switch off.