FAAC 746 C - Programmable Outputs and Indicators; Radio Module Installation

746 C - 844 C 26 532150 - Rev.A
Translation of the original instructions
ENGLISH
PROGRAMMABLE OUTPUTS
J9
OUT 1
OUT 2
1
2
3
4
5
6
7
8
9
10
11
12
IN1
IN2
IN3
IN4
IN5
The E781 has two Open Collector outputs that are acti-
vated according to programming functions
o1 and o2.
OUT active OUT not active
0 V
"
open circuit
Do not exceed the maximum load for each output: 24
V
"
with 100 mA.
FLASHING LIGHT
J4
COM
1
2
LAMP
17
16
15
14
13
230/115 V~
60 W max
The flashing light indicates that the gate is moving
and must be installed in a position that is visible from
both sides of the gate.
The flashing light must be a 230 V~, max 60 W model.
Pre-flashing of 5 s before movement can be enabled
via programming function
PF.
XF FDS/XF RADIO MODULE
The 3-pin quick insertion connector is specifically for
FAAC radio modules XF FDS/XF.
Insert as shown in the figure.
To memorize radio control codes see the section §
Radio system.
RADIO RECEIVER/DECODER BOARD
The 5-pin quick insertion connector is specifically for
FAAC radio or decoder boards.
Insert as shown in the figure.
i
If a FAAC model RP receiver is used, it is recommended
that you install the appropriate external antenna.
SIMPLY CONNECT/XUSB
Example: GSM Mobile module, Bluetooth Low Energy
Insert the module into the dedicated plug connectors
and install the “Simply Connect PRO” app.
i
When programming is taking place via Simply Connect,
programming via the board is inhibited.
MOTOR
The motor is connected at the factory.
J4
M
COM
1
2
MOTOR
17
16
15
14
13