FAAC 746 C - Installing the Gearmotor

910
746 C - 844 C 17 532150 - Rev.A
2
~ 70 cm
x 4
H = 20
1
x 4
19
3
x 4
A
Translation of the original instructions
ENGLISH
3.2 INSTALLING THE GEARMOTOR
1. Make sure that the concrete of the plinth has set
completely, then adjust all the support nuts to the
height indicated in figure (H).
2. Place the washers on the nuts. Remove the cover
from the gearmotor. Position the gearmotor in
correspondence with the 4 fasteners.
- Pass the electric cables through the hole on the
base so that they protrude by approximately 70 cm.
i
Be careful not to damage the electrical cable tubes.
3. Make sure that the gearmotor is level. Insert the
washers and nuts.
- Do not tighten the nuts so that the height can be
adjusted when the rack is being installed.
OPEN THE VENT HOLE
Open the vent hole by removing the screw and washer.
i
A few drops of oil may leak out after the vent hole has
been opened, even due to the initial movements.
Keep the screw and washer (A) as they will have to be
reinstalled before removing the gearmotor, if necessary.