User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 82
Mackie Operation
Pressing the Select button on a Mackie Fader selects its signal path, like pressing its key on the
Xynergi Tactile Controller.
If MULTI is on, the signal path is added (or removed if already ON) from the selection. The
physical fader, Mute button, Solo button and panpot on the Mackie controller affect only this
signal path. The Xynergi Pad Controls, on the other hand, affect the most-recently-selected path,
or all selected paths if MULTI is on.
There is no button on the Mackie faders for putting the signal path into Automation Write. If the
path is selected, the Xynergi
IN button on the Mixer Megamode puts it into Write. The Xynergi
Auto button puts it into Write if it is the most-recently-selected path.
If MULTI is on, all selected paths are put into Write by the Auto button.
Map Faders
Overview
You can create up to 9 Fader Sets. Each of these is a mapping (or distribution) of signal paths to
the faders.
To select a Fader Set, turn on the
Fader Sets button (Numeric Keys glow violet or blue) and
select a number from 1 to 9.
If faders are properly configured using the Xynergi Configure application: Start
All Programs
Fairlight
Xynergi Utils Configure Xynergi, new projects will open with the Tracks and Live
Feeds nicely distributed over the fader sets.
You will need to create your own mappings for different types of projects. This guide shows you
how to map faders to a Fader Set.
Get Ready
Press the green Setup button.
Make sure the Fader Sets button is illuminated, and choose the fader set you wish to map.
Now press the
map faders button.
Operation
The system is mapping the Fader Set whose number is illuminated.
The picture keys show path names. Choose
Tracks, Lives or Buses (which include Fader Group
masters)
Select a path for the first fader. The fader displays the name of that path.
The selection point moves to the next fader. Continue with this process.
Return to any point in the mapping by pressing the
CALL button (or Select button for Mackie) on
a fader.
Press Exit at any time to complete the mapping, or press another Fader Set number to start
mapping that set.
Note: when you start mapping a second or subsequent set, the selection point may not start at
the first fader. Please map something to the selected one, then select or call the first fader to
bring the selection point back to it.
To Next Page
Loading...