User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 87
Press the touch button so that it reads Latch or Snap.
Load a plug-in as follows:
Press the
plug ins button.
Press the
Add Plug soft key.
Use the
Jog Wheel to roll through the list of plug-ins, then press the Add soft key to load one.
If desired, press the
plug ins button again to place the graphics in the Pad.
Operation
Press the play button.
Grab one of the Pad controls affecting the plug-in parameters, and change its value. Its pad area
will go red, indicating Write status. Alternatively, grab the on-screen control and move it with the
mouse. The result is exactly the same.
Continue to write parameter values until happy with the results, then press the
Stop button (or
any other transport button). The pad area should now go green, indicating Read status.
To review your results, press the
Play Menu button twice.
Auto Punch
Overview
Auto Punch performs an automation pass, pre-rolling, then punching in and out at the Range start
and end points. In brief:
Set up to record automation data in the usual way (see How To Automation Pad
Control)
Create a range
Press
Active IN and/or Active Out.
Press
Auto Punch.
Note: Without Active IN pressed, the system will still preroll the Range start. You can then punch
into Write manually with the
Auto button, and the system will punch out automatically.
Without Active OUT pressed, the system will preroll and punch in at the Range start. Press
STOP
manually to go back into Read.
Operation
Select paths
Enable faders and pans
Set On Stop setting
Press the
Path button to acess faders and pans.
Choose
Write or Trim. Trim is only used with physical faders.
Locate to the desired IN point and press
From.
Locate to the desired OUT point and press
To.
Press Active IN and/or Active Out. They light up in red.
To Next Page
Loading...