User Manual HOW TO … February 16, 2010
Xynergi Media Production Centre Page 88
Press Auto Punch to perform the automation pass
Preview
Overview
Preview is a system mode that allows you to suspend automation Read for particular controls
while you find new settings for them.
After finding the new settings you can punch them into the track, or fill a range with them.
Before using preview you must:
Enable paths.
Enable parameters.
Engage Preview.
Press the
AUTO button to put the enabled items into Preview.
This guide shows preview in detail.
Get Ready
Press the green Mixer button.
Press the
mix menu button.
Press the
mix ON button so that it is illuminated.
Operation
To enable signal paths, select them.
Press the param enable button and select faders and pans. Press exit.
Press
preview. The preview button pulses. The AUTO button on Xynergi or on a Fairlight Sidecar
will now put its corresponding path into Preview mode.
Press
AUTO. The Level and Pan backgrounds go yellow, indicating that those parameters are in
Preview.
You can now move these controls, which would not be possible if they were in Read. The
punch
IN
command also becomes available. This takes the system from Preview to Write.
Having obtained the settings you want, use
punch IN, auto punch or fill range to write those
values to the automation. In the first two cases (punch in and auto punch) the previewed values
will start writing when you first punch in, but you can change them freely afterwards. See below
for more information about
fill range.
Join
Overview
Join allows you to “carry” parameter values from one place to another.
In brief:
Write some data into the automation
Locate to another timecode.
To Next Page
Loading...