4. Maintenance
USE AND MAINTENANCE MANUAL CHAPTER 4
MAINTENANCE2-Strokes - Edition 00 / 2023
114
– Check that the cartridge is not damaged, if it is, replace it;
– Clean the cartridge with a dedicated solvent, after cleaning
remove the solvent by pressing the cartridge and blowing
it with compressed air;
– Apply air filter oil to the cartridge, press it to remove the
excess oil.
The cartridge must be damp, but not wet.
– Assemble the air filter on the support by carrying out the
procedures described above in reverse order and checking
that the hooks/pins on the support are fitted correctly.
– Insert the filter support and push it until the pin engages
into the support on the filter housing.
– Fit the side panel again.
To Next Page
Loading...
