2. Use of the vehicle
USE AND MAINTENANCE MANUAL CHAPTER 2
USE OF THE VEHICLE2-Strokes - Edition 01 / 2023
67
2
XX 125 / XX 250 XE 125
1
2.3 REFUELLING
To refuel, turn cap “1” anti-clockwise and lift it up.
After refuelling, insert the cap into the tank and turn it
clockwise.
Do not smoke or use naked flames when refuelling.
Avoid using electrical devices or any source that
can trigger sparks or ignition. Failure to comply
with these rules could result in a danger of fire or
explosion, causing serious damage to property and/
or persons.
Do not add additives or other substances to the fuel
during refuelling.
Avoid fuel leakage during refuelling. If you use a
funnel, make sure that it is perfectly clean.
It is recommended to use the type of fuel indicated
in the technical specifications of this manual. Do
not use different fuels, they could damage the fuel
system and compromise the operation of the engine.
Make sure that the tank cap is closed.
2.4 STARTING THE ENGINE
Starting a cold engine
1. Shift the transmission into neutral.
2. Turn the fuel cock to “ON” and full open the starter knob
(CHOKE).
3. With the throttle completely closed start the engine by
kicking the kickstarter forcefully with firm stroke.
4. Run the engine at idle or slightly higher until it warms up:
this usually takes about one or two minutes.
5. The engine is warmed up when it responds normally to
the throttle with the starter knob (CHOKE) turned off.
Do not warm up the engine for extended periods of
time.
Starting a warm engine
Do not operate the starter knob (CHOKE). Open the throttle
slightly and start the engine by kicking the kickstarter
forcefully with firm stroke.