5. Warranty and service
USE AND MAINTENANCE MANUAL CHAPTER 5
WARRANTY AND SERVICE2-Strokes - Edition 01 / 2023
149
5
Warnings for maintenance and care
The purchaser is responsible for ensuring that maintenance work is carried out at the prescribed intervals and documented by
means of completed, stamped and proof of purchase receipts.
– Always inspect your motorcycle before each use. This check is especially important for your safety.
– Before starting maintenance work, allow the motorcycle to cool down to avoid burns.
– Self-locking nuts once removed must be replaced by new nuts.
– When removing bolts and nuts secured with threadlocking fluid, these must be refitted and secured in the same way.
– When washing the motorcycle, do not use a high-pressure cleaner, as the water may penetrate into the bearings, carburettor,
electrical connectors, etc.
– Dispose of oils, grease, filters, fuel, detergents, brake fluid, etc. by following the regulations in force in your country. Also observe
the safety regulations on the handling of these substances. Under no circumstances should used oil be dispersed into the sewer
system or the environment.
To Next Page
Loading...
