Before starting the engine
2018-02-20 4812325559EN 31
Before starting the machine engine
Be sure that the parking brake (1) is ON, otherwise turn it on.
Turn the engine starter switch (2) to the middle position ("I”).
After the startup screen appears, check if the voltmeter shows
at least 24 Volts of voltage, and if the fuel level shows a
percentage value compatible with the operation.
Make sure all warning lights are working properly.
This machine is adjusted at the factory with the main
preset functions, i.e., four of them with functions in
the local language.
This machine is programmed to shut down the
engine if the operator fails to operate it within the
maximum time limit of 20 minutes.
Visibility
Before starting the engine, make sure that the visibility around
the machine is not impaired.
All cab windows should also be clean and the rear view mirrors
adjusted in order to have a good rear visibility.
Fig. – Side control panel
Fig. – Multifunction display
To Next Page
Loading...
