Festo CP-E08-M8-CL - Connect the Output Module to the CP String

3. Output module type CP−A04−M12−CL
3−8
Festo P.BE−CPEA−CL−EN en 0711a
Note
When switching inductive loads, be sure to use a suitable
safety circuit (e.g. free−whiling diode).
3.3.2 Connect the output module to the CP string
Caution
Fault in data transfer on the CPI/CP string.
Note the maximum permitted string lengths in the manual
for the CPI master used.
You will then avoid faults in data transfer between the
input module and the CP master (e.g.CP fieldbus node).
Caution
Functional damage
Note the maximum permitted string lengths in the manual
for the CPI master used.
Use only the intended original cable type KVI−CP−... from Festo
for connecting the CPI/CP modules, see manual for the CPI
master used.
Note
Specifications on the current consumption of the different
CPI/CP modules can be found in the relevant manuals.