15
5.6 Battery Lo
When Lo. Bat message appears; it means battery level is at extremely low level. Recharge battery immediately.
This instrument will power off automatically when the battery level is extremely low. If this is the case, do not
attempt to power on this instrument. Recharge this instrument immediately. Fail to do so may cause
unrecoverable damages to the built-in rechargeable battery.
5.7 Battery Charging Status
Battery charging status is shown on the dual-color Charge Status Indicator: -
• Red/Yellow: - Recharging in process,
• Green: - Charging completed.
6. Internal Function Settings
6.1 About Internal Function Table
To enable this instrument to give the best performance under various application requirements and demands, a
set of internal functions is built-in.
These internal functions are divided into 2 categories: -
• User accessible functions (F1 ~ F37 of below table) do not request any password to access.
• Other internal functions are not for access to end-users and may need a password to access. Do not
attempt to access or alter any parameters without authorization to avoid system malfunction.
6.2 How to Enter & Select Internal Function
1. In weighing mode, press [Set].
2. Instrument displays F1 and is now in internal function mode.
3. Press [Unit] or [MR] to select the preferred internal function number and press [Print/M+] to enter.
4. Quick access to a function number: -
a. Press [0] to go to F1.
b. Press [1] to go to F10.
c. Press [2] to go to F20.
d. Press [3] to go to F30.
6.3 Key Function during Internal Function Setting & Operation Mode
Refer to paragraph 3.1 for more information.
To Next Page
Loading...