63
E.2 To Edit Custom Lab 2 Print Output Format
Follow the below steps to create a customized printout.
1. Depends on the working modes: -
• Go to F22 to edit custom output for Weighing and ATM mode. Maximum 30 variants can be inputted.
• Go to F23 to edit custom output for Piece Count mode. Maximum 30 variants can be inputted.
• Go to F24 to edit custom output for Animal Weighing mode. Maximum 12 variants can be inputted.
2. Press [Print/M+], then [Unit] until Custom appears.
3. Press [Print/M+],
4. This instrument displays Line 1 and the last variant or command (refer to Appendix E.2 for more
information) stored,
5. Press [Print/M+] to confirm or select other variant or command by pressing [Unit] or [MR]. Press
[Print/M+] to confirm and save,
6. This instrument displays Line 2 and the last variant or command stored,
7. Repeat steps 4 and 5 for other lines,
8. To finish editing, select End and press [Print/M+] to confirm,
9. This instrument returns to and displays the current internal function number.
At this point, customized Lab2 output format editing is completed.
To Next Page
Loading...
