Fidelity Electronics A10 - Appendix V: Production Settings PLU Execution Commands

97
Appendix V: Production Settings PLU Execution Commands
Production Settings PLU reading commands format as below: -
a. Start String * “asterisk” (Hex code 02A), then followed by
b. Command string listed on below table, then followed by
c. Parameters listed on the below table. Always insert semicolon (;) in front of each parameter, followed by
d. End String # “number sign” (Hex code 23).
Notes: -
 For RS485 communication, add @xx before start string.
 xx = machine ID number set in F18.
Command Description Table
Start
String
Command Code
(Note V1)
Parameter
End String
*
E1 or E2 or E3
LP
;00~ ;99
(00~99 = Production Settings PLU number)
#
Note V1: -
• E1 = command to execute Production Settings PLU of weight unit kg.
• E2 = command to execute Production Settings PLU of weight unit g.
• E3 = command to execute Production Settings PLU of weight unit lb.