Fidelity Electronics A10 - Appendix R: - Quick PLU Saving Commands

89
Appendix R: - Quick PLU Saving Commands
Quick PLU saving command format as below: -
a. Start String * “asterisk” (Hex code 02A), followed by
b. Command code as shown on below table (all commands are case sensitive), followed by
c. Parameters listed on the below table. Always insert semicolon (;) in front of each parameter, followed by
d. End String # “number sign” (Hex code 23).
Notes: -
 For RS485 communication, add @xx before start string.
 xx = machine ID number set in F18.
Command Description Table
Command Definition
Command Format
Parameter Description
Start
String
Command Code
(Note R1)
Parameter &
End String
Save Preset Tare to Quick
PLU
*
S1/S2/S3
QP
PSTA
;d1;d2#
 d1 = Quick PLU number 0~9.
 d2 = Preset Tare value. Maximum 8 digits plus
decimal.
Save Average piece weight
to Quick PLU
*
S1/S2/S3
(Note R2)
QP
AVGW
;d1;d2#
 d1 = Quick PLU number 0~9
 d2 = Average piece weight value. Maximum 8
digits plus decimal
Save Check WT Limits to
Quick PLU
*
S1/S2/S3
QP
CHKW
;d1;d2;d3#
 d1 = Quick PLU number 0~9.
 d2 = Low check limit. Maximum 8 digits plus
decimal.
 d3 = Hi check limit. Maximum 8 digits plus
decimal.
Save Check QTY Limits to
Quick PLU
*
ST
QP
CHKQ
;d1;d2;d3#
 d1 = Quick PLU number 0~9.
 d2 = Low check limit. Maximum 8 digits.
 d3 = Hi check limit. Maximum 8 digits.
Save Customer Code and
Description to Quick PLU
*
ST
QP
CCDE
;d1;d2;d3#
 d1 = Quick PLU number 000~999
 d2 = Customer Code. 1~18-digit (* or and # will
not be accepted). Blank = Nothing.