36
11.3.2 Recall preset tare from quick PLU
Follow the below steps to recall preset tare value from quick PLU.
1. Select desired weight unit.
2. Go to desired operation mode. Then press and hold [Tare] for 2 seconds.
3. Instrument displays PT =?. Press PLU position (numeric key 0 ~ 9) and press [Print/M+] to recall the
preset tare value stored in that position.
4. Instrument displays the Lo and Hi weight check limits and these values are now effective.
11.3.3 Clear preset tare from quick PLU
Refer to paragraph 11.3.1. Input zero value in step 2.
11.4 Customer/Product Code & Description Quick PLUs
11.4.1 Create & save customer/product code & description to quick PLU
1. Go to Customer/Product code setting manual by either one of the below methods.
a. If Quick Manual Code Setting function (CPd) in F11 is set to on: -
• Press [Func] then [Unit] until C.P. Code appears and press [Print/M+].
• Press [Unit] until the desired mode appears (select C Code for customer code & description
or P Code for product code & description) and press [Print/M+] to confirm.
b. If Quick Manual Code Setting function (PCd) in F11 is set to Off: -
• Go to F19 and press [Print/M+].
• Press [Unit] until the desired mode appears (select C Code for customer code & description
or select P Code for product code & description) and press [Print/M+] to confirm.
2. Instrument displays previous code inputted (if any).
3. To move cursor to one place left/right, press [Unit]/[MR].
4. Input the preferred code (maximum 18 digits) and press [Print/M+] to confirm.
5. Instrument prompt for description.
6. Input the preferred description (maximum 30 digits) and press [Print/M+] to confirm.
7. Instrument displays Save=?. At this point: -
a. Press the preferred PLU position (numeric key 0 ~ 9) and press [Print/M+] to save to that
PLU position, or
b. Press [Print/M+] to utilize the code immediately but without saving to PLU.
8. To go to other internal functions, press [Unit] or [MR], or press [Zero] to quite to operation status.
11.4.2 Recall customer/product code & description from quick PLU
Follow the below steps to recall Customer/Product Code & Description from quick PLU.
1. Select desired weight unit.
2. Go to desired operation mode. Then press and hold [0] for 2 seconds.
3. Instrument displays P Code. At this point: -
a. To recall product code & description, simply press the PLU position (numeric key 0 ~ 9) and press
[Print/M+] to recall.
b. To recall customer code & description, press [Unit] to change to display to C code and press
[Print/M+] to recall.
c. To quit, press [Zero].
To Next Page
Loading...