37
11.4.3 Clear customer/product code & description from quick PLU
Refer to paragraph 11.4.1, press [Clear/x10] until all data is cleared, and press [Print/M+] in step 4.
11.5 Average Piece Weight Quick PLU
11.5.1 Create & save average piece weight to quick PLU
Follow the below steps to average piece weight to PLU.
1. Select desired weight unit.
2. Go to Piece Count mode.
3. Press [Unit] twice to go to average piece weight entry page.
4. Input the average piece weight. Then press and hold [Set] for 2 seconds.
5. Instrument displays Save =?. At this point: -
a. Press the preferred PLU position (numeric key 0 ~ 9) and press [Print/M+] to save to that
PLU position, or
b. Press [Print/M+] to utilize this preset tare value immediately but without saving to PLU, or
c. Press [Zero] to quit.
11.5.2 Recall average piece weight from quick PLU
Follow the below steps to recall the average piece weight from quick PLU.
1. Select desired weight unit.
2. Go to Piece Count mode.
3. Press [Unit] twice to go to average piece weight entry page.
4. Short press [Set].
5. Instrument displays PT =?. Press PLU position (numeric key 0 ~ 9) and press [Print/M+] to recall the
average piece weight stored in that position.
6. Instrument displays the average piece weight values, and it is now effective.
11.5.3 Clear average piece weight from quick PLU
Refer to paragraph 11.5.1. Input zero value in step 4.
12. Piece Count Mode
1. At Weighing mode, select the desired weight unit.
2. Go to Piece Count mode.
3. Refer to paragraph 10 and 11 if data related functions are needed.
4. If zero weight cannot be obtained when unloaded, press [Zero]. Zero Indicator lights up when
instrument is at zero status.
5. If a container is used, place it and press [Tare].
6. At this point: -
a. To recall the last average piece weight used before powered off, press [MR].
b. To recall average piece weight from quick PLU, refer to paragraph 11.5.2.
c. If average piece weight value is known, then go to paragraph 12.1.
d. If average piece weight value is not known, then go to paragraph 12.2.
To Next Page
Loading...