the same of the previous parameters and also the fun
-
ctionality of the Cursors, Esc and Enter key is the same
(see Fig.45d).
4 KEY- OUTPUT
The Outputs option, KEY 4 in the PROGRAMMING
menu, activates the output programming screen. It is
used to select the type of Output; followed by the pro
-
gramming procedure for that output.
n
Choose Output
In this phase:
Alphanumeric keypad The Alphanumeric keypad is
used to enter the number of SC output.
Cursor Keys
The UP Key: shows the next output cate
-
gory (SC-OC).
The Down Key shows the previous output category.
Right and Left keys: no functions is related to these keys.
ESC Key
Use ESC key to cancel the operation and to
step back to previous page.
ENTER Key Use the ENTER key to accept the selec
-
tion and activate the output selection and activate the
loop device programming page if the output exists, ot
-
herwise a warning page is displayed for 5s.
"WRONG VALUE! enter the parameter again"
After 5s the User Interface moves back to the page for
selecting the outputs.
+
Once the Output has been programmed (type and
identification number) and the ENTER key is pres-
sed to accept the selection, enter the label for that
output.
n SC on disablements
In reference only to SC2 programmable output, the SC
Outputs can be programmed to activat on disablement
of any part of the system.
+
This feature will be available for all programmable
control panel outputs and for loop modules which
provide dry contacts. This is the list of the devices
affected by the modification: programmable con
-
trol panel outputs: OC1, OC2 and FIRE.
Loop modules: FC410RIM, FC410SIO,
FC410MIO, FC410QMO, FC410QRM, FC410QIO
From PROGRAMMING Menu select Output (KEY 4)
and then work through the steps shown in Figure 47:
-select the SC2 to program the option “SC on disable
-
ments”;
-in the subsequent display diplay insert the name of
Output and than press ENTER;
-in the following diplay, press ON to enable the new op
-
tion and then press ENTER. In this phase:
Cursor Keys
No function is related to Up key;
No function is related to Down key;
Use the Right key to select: On-OFF;
Use the Left key to select: On-OFF.
ESC key
Use ESC key to cancel the operation and to
step back to previous page.
ENTER key
Use the ENTER key to accept the selec
-
tion and activate the programming page.
+
If the SC2 has this option programmed, it will be not
silenceable.
The parameters that may be programmed via panel’s
User Interface
-Output label
-Trigger zone #1
-Trigger zone #2
Events trigger alarm zone, as shown below:
-ALA alarm
-DLY Delay to Alarm
-WAR warning
-FAU fault
-TST test
-DK Double knock.
-Silenceable Output or Not.
Programming procedures and functions of the keys are
the same as for the SC on disablements.
5 Key- Network
The Network option of Programming menu activates
the procedure to configure the modules FC500MFI.
When all the Control panels and the FC500MFI modu
-
les are connected in the Network,
1- use the 5 Key to select Network, from Programming
page (Figure 39) in the User interface;
2- the Display of Figure 48 will be shown;
3- moving with the arrow keys to select the FC500MFI
module to be configured ï or ð (the symbol ^ under
the name show the selected module),
52 Addressable Fire Panel FC501
System lev3. : PROGRAMMING
FC500 MFI MASTER Panel
on1 on2 on3 on3
^
Symbol show the selected module to enable
If it blinks the panel
is operating normall
To Next Page
Loading...
