enable a FC500MFI module by the arrow ñ or disable it
by the arrow ò:
the module name will appear in uppercase if enabled.
Press the Enter key to confirm.
In the ANALYZE status (L1 level): to display the related
status is used an acronym. The acronym are:
" OK!", The net. device is sensed as connected and
working;
" ko!", The net. device is sensed as not connected
" FAU", The net. device is faulty
" DIS", The net. device is disabled
" -- ", The net. device is not configured in the network
" OLD", The net. device has an obsolete FW version.
+
For an explanation of the features and program
-
ming (addresses), see the dedicated manual of the
FC500MFI module.
In this phase:
Alphanumeric keypad No function is related to the
Alphanumeric keypad.
Cursor Keys
The Up key enables the selected modu
-
le (e.g. ON1-uppercase).
The Down key disables the selected module (e.g.
on1-lowercase).
Use the Right key to select the module.
Use the Left key to select the module.
ESC Key
Use ESC key to abort the programming pro-
cedure.
ENTER key
Use the ENTER key to confirm the pro
-
gramming procedure and to leave the page.
6 KEY - MAP DEVICE
This option activates the "On Demand device mapping"
feature to modify the devices addressing scheme in a
working system. In a system where the addressing
scheme is well known because all devices are singu
-
larly addressed via Service Tool or via the "device map
-
ping" feature embedded in the loop enroll process (1
KEY). This means that this new feature is not intended
to acquire new devices on the loops (for this purpose
the Enroll feature have to be used).
Differently from the "device mapping" feature embed
-
ded in the loop enroll process, the "On Demand" ver
-
sion will not automatically modify: devices labels and
assigned zone (see Figures 49, 57).
+
All the devices, comprised also the "unique" types
will put in the "activated list". The "only output" type
devices are treated as in the standard device map
-
ping procedure (they will be singularly activated
when selected in the list).
In this phase:
Alphanumeric keypad The Alphanumeric keypad is
used to enter the new address value: 0-9;
Cursor Keys the UP key, Short press: to scroll to the
previous event in the list, Long press: to start the auto-
matic scroll of the previous event in the list.
the Down key, Short press: to scroll to the next event in
the list, Long press: to start the automatic scroll of the
next event in the list.
The RIGHT key: to program the selected device;
The LEFT to continue the mapping procedure.
ESC key The ESC key: to end the mapping procedure
and exit.
ENTER key the ENTER key: to confirm the entered ad
-
dress value.
+
To stop the automatic scroll, short press of the UP
or Down key.
7 KEY -USB
The option USB in the PROGRAMMING menu activa
-
tes the USB programming page. 7 Key is used to select
USB programming page, Figure 50 shows:
0) Extra
1) Load Audio
2) Save Audio
3) Load programming
4) Save programming
5) FW Upgrade
6) Save LOG.
In this phase:
Alphanumeric keypad Allows the selection of USB
activities.
0) While the panel is running it will be possible to load
the two languages present in the USB key flash me
-
PROGRAMMING FROM THE PANEL 53
FC501 Panel lev.3 : PROGRAM
To Next Page
Loading...
