+
If the motherboard of the Panel is connected with a
FC500IP module, the procedure to Restore factory
Default (key 9) will have no effect on the FC500IP
module. To restore the FC500IP module to factory
default use the procedure of the FireClass Conso
-
le software.
FC500REP Repeater Address
from the Repeater panel ONLY
After the FC501 control panel has been connected, at
the first start-up the FC500REP will verify the presence
of the address and its conformity. If the address is cor
-
rect, the Repeater will start to work; if the address is not
correct the display will ask to insert a new address. The
display on Figure 56 will be shown; in this phase:
Alphanumeric keypad Use the alphanumeric keypad
to insert the address of 1 digit.
Cursor Keys
No function is related to UP, Down,
Right and Left Keys;
ESC Key
Use ESC key to cancel the operation and to
step back to previous page.
ENTER Key Use the ENTER Key to confirm the ad
-
dress.
+
If for any reason the address of a repeater is chan
-
ged by mistake, the system will show the message
in the Figure 56, in this case the address of the re
-
peater can changed using the ESC key.
(1) In the Dutch version of Control panel, (Dutch
language, as the language of Panel),
56 Addressable Fire Panel FC501
!!FAULT!!
Serial link is down
unable to communicate with the system
press ESC to change repeater address
Figure 56 Display "the repeater link is down"
To Next Page
Loading...
