Operator‘s Manual FERITSCOPE
®
FMP30 Page 13
Description of the Instrument
With Application selection and tolerance limit input: Changes
the information displayed on the display.
With the calibration: Sets the target value of the used calibration
standard that will be displayed after the “CAL Target” notifica-
tion.
With parameter selection: Selects the desired parameters.
The display will change faster if
is pressed for longer than 3
seconds.
with external start enabled: Triggers a measurement.
Turns the “free-running” display mode on/off.
With Application selection and tolerance limit input: Changes
the information displayed on the display.
With the calibration: Sets the target value of the used calibration
standard that will be displayed after the “CAL Target” notifica-
tion.
With parameter selection: Selects the desired parameters.
The display will change faster if
is pressed for longer than 3
seconds.
APPL No Selects the desired Application.
.. and then DEL:
Deletes the selected Application;
.. and then APPL No:
Displays the probes assigned to the Applications.
.. and then
or :
Selects the desired Application.
.. and then ENTER:
Confirms the selection of the desired Application and returns to
the measurement screen.
Key Function
To Next Page
Loading...