Operator‘s Manual FERITSCOPE
®
FMP30 Page 179
Instrument Settings - Service Function Menu
10.7.5 Unit
You can specify the unit of measurement for making measurements in the
newly set up Application.
Key sequ. /
Action
Detail of the display Explanation
Select Measurement by pressing the arrow
key
or and confirm the selection with
ENTER.
ENTER
Select Unit by pressing the arrow key
or
and confirm the selection with ENTER.
ENTER
Select the desired unit by pressing the ar-
row key
or .
The change of the unit does not occur until
a new Application is set up.
[Fe%]: The
-ferrite content display in ferrite
percent.
[FN]: The -ferrite content display is in fer-
rite numbers.
[always ask]: When setting up a new Ap-
plication, you will be asked for the unit of
measurements to be used 5.1 ‘Setting
Up an Application’, beginning on Page 37.
Confirming with ENTER will return you to
the menu for the measurement.
Use DEL at any time to cancel the proce-
dure.
To Next Page
Loading...