FlexRadio Signature FLEX-6000 Series

To Next Page

To Previous Page

FLEX-6000 Signature Series – Maestro User Guide

 Mode - The Modulation/Demodulation mode for the Slice (e.g. USB, CW, FM, etc.). Initially

set to the Active Slice mode.

 Step – The frequency step size in Hertz, associated with this setting.

 OffsetDirection - If in FM mode, this sets the direction for the repeater transmitter offset.

Options are Down, Simplex, and Up. Initially, this will be set to the matching setting in the

Active Slice.

 RepeatersOffset - The offset in MHz. Initially, this will be set to the matching setting in the

Active Slice.

 ToneMode - In FM transmit, this can be set to Off or CTCSS TX for PL tones. Initially, this

will be set to the matching setting in the Active Slice.

 ToneValue - The tone value in Hz to use for CTCSS TX

 Squelch – Turns FM Squelch on or off.

 Squelch Level – The Squelch threshold value.

 RF Power - The power setting from 0-100 to use for this memory.

 RX Filter Low - The Receive Filter Low Cut in Hz

 RX Filter High - the Receive Filter High Cut in Hz

 RTTY Mark - The mark frequency when using RTTY mode

 RTTY Shift - The shift frequency when using RTTY mode

 DIGL Offset - The offset when using DIGL mode

 DIGU Offset - The offset when using DIGU mode

Note: Memories and Profiles are two separate features that may appear similar. However,

memories record a relatively small number of radio configuration parameters, as listed above,

while Profiles record many more parameters.

FlexRadio Signature FLEX-6000 Series - Page 112